#Change mac address using terminal emulator serial

#Change mac address using terminal emulator serial

To go to the host serial console (host COM0), type the following commands:

You can now run CLI commands.ДЇor example, to display status information about the motherboard in your server, type the following command:Д§. Once you have successfully logged in, the ILOM displays the ILOM default command prompt: It consists of the prefix SUNSP and the ILOM's MAC address. The first string in the prompt is the default host name. When the system has booted, the ILOM displays its login prompt: Note - If you connect a terminal or emulator to the serial port before it has been powered up or during its power up sequence, you will see bootup messages. This establishes the connection between the terminal device and the ILOM. Note that these are the same as the serial cable connector for the Sun Advanced Lights Out Manager (ALOM) or Remote System Control (RSC). Note - The serial port requires that the serial cable connected to it use the following pin assignments. Refer to your -specific documentation or the supplement for the location of the serial port. Refer to your platform-specific documentation for instructions on installing the hardware, cabling, and powering on.Д¤.Дњonnect a serial cable from the serial port on the server's back panel to a terminal device. Unpack your server and connect the system power cable to a power source. Disable hardware flow control (CTS/RTS)ДЈ.8N1: eight data bits, no parity, one stop bit.Verify that your terminal, laptop, or terminal server is operational.Дў.Дњonfigure that terminal device or the terminal emulation software to use the following settings:

You can access the ILOM CLI at any time by connecting a terminal or a PC running terminal emulation software to the RJ-45 serial port on the ILOM board.ДЎ. 2.1 Connecting to the ILOM Using a Serial Connection